PostProcess:How to output force(like collisions) between DEM solids
Hello everyone,
I noticed that the force calculation part in PostProcess is mainly about fluid force. But I also want to analyse the force between DEM solids like collision and friction.
Is there anyway to directly output the datas mentioned above?
If not, is there some guidance about how to output it?
Thanks in advance
Comments
Look at Chrono output in your directory. Should have that information.
Thanks for your help. But I used the DEM function. So it didn't have Chrono output.
Oh I see, you are right my bad!
Then my advice would be to use Chrono, instead of DEM ;-)..
Depends on use case of course!
Kind regards