Hi i have a question .. I want to measure the height of the water surface over time in a regular wave example , but when i use measure tool in freecad , The height result is always equal to the height of the point which I set. so how can i get the results?
thank you
Comments
Hi,
Measuretool works fine for me. Can you share your "point" parameters ?
thank you for your reply
my water tank's length is 7.5m, width is 2.5m, height is 2m, water height is 1.0m;
piston's length is 10mm, width is 2.5m,height is 1.5m;
the motion of piston is "regular wave generator (piston)",wave order is "2nd order",depth is 0.4m, wave height is 0.1m,
I refer to the official tutorial "how to set up and run :casewaves";
the "list of points" in the measuretool is"2.5, 1.25, 1.0",the result height is all equal to1.0,
the"grid of pionts" is "1.0, 1.25, 0.1; 0.0, 0.0, 0.02; 1.0, 1.0 20.0",the result height is all equal to 0.48,
Hi again,
for the "2.5 1.25 1.0", you should provide a grid also, something like
2.5 1.25 1.0
0 0 0.02
1 1 100
for the second example you provide, for the Z parameter you have: start at 0.1, every 0.02, 20 times
and it gives you 0.48, I think it is normal. It means that the true water level is higher (0.48 = 0.1 + 0.02*(20-1), it gives you the highest point of the evaluation
Regards
oh, thank you my bro ,i got it
best regards to you