Boundary particles moving out of the domain

brijithu

From the FAQs I coul see the following

-domain_particles[:xmin,ymin,zmin,xmax,ymax,zmax]
The domain is fixed as a function of the initial article positions and modified for xmin,...
-domain_particles_prc:xmin,ymin,zmin,xmax,ymax,zmax
The values in proportion with the case dimensions according to the initial particles.
-domain_fixed:xmin,ymin,zmin,xmax,ymax,zmax
The domain is fixed with the specified values.

1.What is the difference between the first two commands viz: -domain_particles and -domain_particles_prc?
2.Are these to be supplied while executing the gencase or the batch file or both?
3. There was another option called 'draw point' instead of point min and point max , where/ how to use that?


Any general help to tackle the problem will also be appreciated
Thanks a lot

brijithu

Threads by host for parallel execution: 8

[Initialising JSphCpuSingle v0.70 20-02-2018 18:18:34]
**Basic case configuration is loaded
**Special case configuration is loaded
Loading initial state of particles...

*** Exception (JBinaryDataArray::GetDataCopy)
Text: There are not available data in Pointer or FileData.


Execution aborted.
Press any key to continue . . .


I'm alternating between these two errors, this one and the boundary particle moving out, can any one please help me out

Alex

Please check first the particles created by GenCase

brijithu

Alex, thanks alot for your reply, I solved my boundary particles moving out, now my fluid particles are flowing down the beach (made using prism command) and getting emptied as if there is a hole.The same error persist even when I replace the prism with beach command.I'm scanning the whole code for any open boundaries but couldn't find any.I'm doing the case wave generation with a jacket surrounded by water and subjected to waves